Cement screw conveyor has strict requirements in operation in order to enable screw conveyors have a long service life, please remember the following points when conveying materials:
1. When screw auger starts to feed, the material should be gradually increased, and finally the material should be evenly distributed. The material can not be added to the rated quantity instantaneously,otherwise, the plugging will occur and the drive device will be overloaded, which will have a certain influence on the service life of the equipment.
2. There must not be hard bulk materials in the material,otherwise, the
screw auger blades will be jammed and the blades will be deformed, at the same time, the motor also will be burned.
3. Do not feed material when starting up, wait for start-up before feeding, and start the conveyor without load.
4. Stop the feeding before stopping and wait until the material in the casing is finished then, stop the machine.
5. Regularly check the various parts of the conveyor, such as whether the fasteners are loose, if there is looseness to be fastened in time, so as to prevent in advance.
6. When the conveyor is in operation, it is not allowed to remove the cover so as to avoid personal injury and often to add lubricant to the moving parts.
7. For viscous materials, clean the inner wall of the casing and the screw body in time to prevent the residual material corrode the conveyor.
Since the use of the screw conveyor environment is generally dusty occasions, the bearing of the conveyor will increase its wear in the dust for a long time, so the
pipe screw conveyor should be regularly maintained and lubricated to allow the conveyor to work better.
More information, please visit:
www.pkmachinery.com
